Sub-Zero 427G - Manual (Page 29)

subzero.com | 29
MODEL WS-30 INSTALLATION
Alignment
DOOR ADJUSTMENT
The door can be adjusted in and out, side to side tilt and up
and down.
To make adjustments, slightly loosening the two upper hinge
bolts on the upper hinge plate using a
1 / 2 " wrench. Refer to
the illustration below.
In and out adjustment | For a left-hinge door, using a
5 / 32 " allen wrench, turn the adjustment bolt clockwise to
bring the handle side of the door inward, and counterclock-
wise to move the handle side outward. Reverse directions
for a right-hinge door.
Side to side tilt adjustment | For a left-hinge door, using a
3 / 8 " wrench, turn the adjustment bolt clockwise to raise the
handle side of the door, and counterclockwise to lower the
handle side. Reverse directions for a right-hinge door.
Up and down adjustment | For a left-hinge door, using a
1 / 4 " allen wrench, turn the adjustment bolt clockwise to raise
the door and counterclockwise to lower. Refer to the illustra-
tion below. Reverse directions for a right-hinge door.
UPPER
HINGE BOLTS
SIDE TO SIDE
TILT ADJUSTMENT
IN AND OUT
ADJUSTMENT
Door adjustment bolts.
Up and down door adjustment.
Completion
GRILLE INSTALLATION
Install the grille assembly and check for proper fit. The grille
is designed to rest on the upper door hinge to minimize the
reveal between the top of the door and bottom of the grille.
To eliminate interference, the grille height can be adjusted.
Loosen the four grille adjustment screws (two on each side)
and adjust the grille height as needed. Refer to the illustra-
tion below.
FRONT
GRILLE SCREW
BACK GRILLE
SCREW
GRILLE
ADJUSTMENT
SCREWS
Grille height adjustment.