beautypg.com

Sony GRAND WEGA KF 42WE610 User Manual

Page 7

background image

7

Servicing

Do not attempt to service the set by yourself
since opening the cabinet may expose you to
dangerous voltage or other hazards. Refer all
servicing to qualified service personnel.

Replacement Parts

When replacement parts are required, be sure the service
technician certifies in writing that he has used
replacement parts specified by the manufacturer that have
the same characteristics as the original parts.

Unauthorized substitutions may result in fire, electric
shock or other hazards.

Safety Check

Upon completion of any service or repairs
to the set, ask the service technician to
perform routine safety checks (as specified
by the manufacturer) to determine that the
set is in safe operating condition, and to so
certify. When the set reaches the end of its
useful life, improper disposal could result
in a picture tube implosion. Ask a qualified
service technician to dispose of the set.

For Safety

Be careful when moving
the LCD Projection TV

When you place the LCD Projection
TV in position, be careful not to
drop it on your foot or fingers.

Watch your footing while installing
the LCD Projection TV.

Carry the LCD Projection TV in
the specified manner

If you carry the LCD Projection TV in a
manner other than the specified manner
and without the specified number of
persons, it may drop and a serious injury
may be caused. Be sure to follow the instructions
mentioned below.

Carry the LCD Projection TV with the specified
number of persons (see page 18).

Do not carry the LCD Projection TV holding the
speaker grill.

Hold the LCD Projection TV tightly when carrying
it.

About the LCD Projection TV

Although the LCD projection TV is made with high-
precision technology, black dots may appear or bright
points of light (red, blue, or green) may appear constantly
on the LCD screen. This is a structural property of the
LCD panel and is not a malfunction.

Installation

If direct sunlight or other strong illumination shines
on the screen, part of the screen may appear white
due to reflections from behind the screen. This is a
structural property of the LCD Projection TV.
Do not expose the screen to direct illumination or
direct sunlight.

The picture quality may be affected by your viewing
position. If you sit too close to the TV, you may
suffer from eye fatigue.
For the best picture quality, install your LCD
projection TV according to the operating
instructions.
Sit at least 1.8m (approx. 5.9ft.) for KF-42WE610,
2.0m (approx. 6.6ft.) for KF-50WE610 or 2.2m
(approx. 7.2ft.) for KF-60WE610 away from your
LCD projection TV, and within 60° of the vertical
viewing area, and 130° of the horizontal viewing
area.

When installing your LCD Projection TV against a
wall, keep it at least 10 cm (4 inches) from the wall.

Avoid installing the LCD projection TV close to
high temperature sources such as a heater.

Projection lamp

Your LCD projection TV uses a projection lamp as
its light source. When the projection lamp wears out
after using the LCD projection TV for a long period
of time, the screen image becomes dark, or no image
will appear on the display. If the lamp replacement
indicator of the front panel blinks in red, replace the
lamp with a new one (not supplied). In some cases,
the bulb bursts inside the lamp unit noisily, but the
lamp unit is securely designed so that the pieces of
broken glass remain inside the lamp unit. (See
“Replacing the Lamp” on page 13.)

Cooling fan

This LCD projection TV uses a cooling fan. You
might hear the noise from the cooling fan,
depending on the place you install the LCD
projection TV.

Carrying

Before carrying the LCD projection TV, disconnect
any accessories or cables.

Remote control detection

The remote control sensor is at the upper right side
of the TV. For the best results, aim the remote
control at this location.

This manual is related to the following products: