Siemens HIPATH 500 - Manual (Page 100)

Appendix
92
Appendix
Troubleshooting
Some malfunctions can be resolved without outside intervention. The fol-
lowing table provides a list of such malfunctions.
Error Possible cause Remedy
No display. Handset not switched
on. Press the On-hook key
until confirmation is re-
ceived.
Battery is empty. Charge or replace the
battery.
No reaction to key-
stroke. Keypad lock activated. Press the hash key until
confirmation is re-
ceived.
De-crescendo tone se-
quence during input. An incorrect entry was
made. Repeat key sequence
while watching the dis-
play; where applicable,
consult the operating
instructions.
The line "Base n" flash-
es (n= 1 - 4). The handset is outside
the base radio range;
Radio signals too weak. Come closer to the
base radio range,
change your position.
Handset not regis-
tered. Register the handset.
Intervals between syn-
chronisation attempts
are too long. Switch off the handset
and switch it back on
again.
No ringer on the hand-
set. Ringer is deactivated. Activate ringer.
Nothing audible during
a call. The "R key" was
pressed – the micro-
phone and the receiver
inset are muted. Press the "Delete" Dis-
play key to re-activate
the microphone and
the receiver inset.
The following appears
immediately after the
Talk key is pressed:
Connect.
No dial tone available;
No calls can be made.
Communication sys-
tem is being used by
other users. Repeat call later.