Sony J30SDI - Manual (Page 19)

Chapter 2
Location and Function of Parts
2-8
Chapter 2 Location and Function of Parts
2-2-1 Connector Panel of the J-10/30
2-2 Connector Panel
2 RS232C connector
5 VIDEO OUTPUT
connectors 6 AUDIO MONITOR
OUTPUT connectors
1 AC IN connector
3 REMOTE IN (9P) connector
4 EXT SYNC input connector
1 AC IN connector
Connects to an AC outlet using the power cord (not
supplied).
2 RS232C (RS-232C serial interface) connector
(D-sub 9-pin)
Used to send or receive RS-232C remote control
signals and VTR status signals to/from an external
device such as a computer with the JZ-1 installed.
3 REMOTE IN (9P) connector (RS-422A serial
interface, 9-pin)
Controls the unit remotely from an external device
equipped with the Sony 9-pin remote control function.
4 EXT SYNC (external synchronization) input
connector
Inputs the reference video signal. However, on this
unit, use this for frame synchronization only, not for
color subcarrier synchronization.
5 VIDEO OUTPUT connectors
COMPOSITE (analog composite video) (SUPER)
output connector (phono jack): Outputs an analog
composite video signal. When basic menu item
005, DISPLAY INFORMATION SELECT, of the
setup menu is set as anything other than OFF, the
output from this connector outputs superimposed
character information such as time code, menu
settings, or alarm messages.
COMPOSITE (analog composite video) (SUPER)
output connector (BNC): Outputs an analog
composite video signal. When basic menu item
005, DISPLAY INFORMATION SELECT, of the
setup menu is set as anything other than OFF, the
output from this connector outputs superimposed
character information such as time code, menu
settings, or alarm messages.
S VIDEO output connector (Mini-DIN 4-pin):
Outputs an S VIDEO signal.