beautypg.com

Installation window, Frame adjust, Lens control – Sony SRX- R110 User Manual

Page 28: Progressive display mode, Lamp power

background image

GB

28

INSTALLATION Window

Cha

pte

r 4
A

d

jus
tment

s

a

nd Set

tings
Us

ing t

he SRX Con

tro
ller

Frame Adjust

Adjusts the horizontal size and the position of the picture.
Clicking

increases the setting value, and

decreases it.
Clicking the RESET button resets all the settings of
“Frame Adjust” to the factory-preset values.

Dot Phase: Adjusts the phase of the SXRD panels and the

input signal. Adjusts the value to obtain the clearest
picture.

H Size: Adjusts the horizontal size of the picture according

to the input signal. As the setting value increases, the
horizontal size of the picture becomes larger.

H Shift: Adjusts the horizontal position of the picture. As

the setting value increases, the picture moves to the
right. As the value decreases, the picture moves to the
left.

V Shift: Adjusts the vertical position of the picture. As the

setting value increases, the picture moves up. As the
value decreases, the picture moves down.

• Adjustment of “Dot Phase” and “H Size” is available for

computer signal input only.

• If the position of the picture is not adjusted correctly,

noise may appear in the blank portion of the screen. This
is not a malfunction of the projector. Adjust the picture
position correctly with “Frame Adjust.”

INSTALLATION Window

The INSTALLATION window is used to adjust the
projected picture, change the lamp output, etc.

LENS CONTROL

Adjusts the projected picture on the screen.

Zoom +/–: Adjusts the size of the picture. Clicking

enlarges the picture size, and

reduces the picture

size.

Focus +/–: Adjusts the picture focus. Clicking

focuses

on a forward picture. Clicking

focuses on a

picture further back.

Shift +/–: Adjusts the vertical position of the picture.

Clicking

moves the picture upward. Clicking

moves it downward.

PROGRESSIVE DISPLAY MODE

Normally, click the Off radio button.
Click the On radio button when four HD images with 2048
(1920) × 1080 pixels are input from four HD-SDI input
boards and are combined into a 4096 (3840) × 2160-pixel
image on the screen in “quad-screen” mode.

LAMP POWER

Adjusts the lamp power output. You can reduce the lamp
power to 93%, 86%, 79%, 72%, 65%, 58% or 51%. The
brightness of the projected image will be darker, but power
consumption can be reduced and this increases the lamp
life. Clicking the 100% radio button allows you to obtain
the brightest projection image.

Switching the lamp output frequently may reduce the lamp
life. Use of the defined lamp output is recommended.

Notes

Note

This manual is related to the following products: