SUPER MICRO Computer SUPERSERVER 6015B-3 - Manual (Page 63)

Chapter 6: Advanced Chassis Setup
6-5
Accessing the Drive Bays
SAS/SATA Drives: Because of their hotswap capability, you do not need to access
the inside of the chassis or power down the system to install or replace SAS or
SATA drives. Proceed to the next section for instructions.
DVD-ROM/Floppy Disk Drives: For installing/removing a DVD-ROM or fl oppy disk
drive, you will need to gain access to the inside of the 6015B-3/6015B-T by removing
the top cover of the chassis. Proceed to the "DVD-ROM and Floppy Drive Instal-
lation" section later in this chapter for instructions.
Note: Only "slim" DVD-ROM and fl oppy drives will fi t into the 6015B-3/6015B-T.
Figure 6-3. Removing the Front Bezel
1. Unlock
2. Press release knob
3. Remove bezel assembly