SUPER MICRO Computer SUPERSERVER 6015B-3 - Manual (Page 45)

Chapter 5: Advanced Serverboard Setup
5-11
X7DBR-3/X7DBR-E Quick Reference
Jumper Description Default Setting
J3P 3rd Power Fail Detect Open (Disabled)
JBT1 CMOS Clear (See Section 5-9)
JCF1 Compact Flash Master/Slave Select Closed (Master)
JI 2 C1/JI 2 C2 SMB to PCI Open (Disabled)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
JPS1* SAS Enable/Disable Pins 1-2 (Enabled)
JPL1/ JPL2 JLAN1/JLAN2 Enable/Disable Pins 1-2 (Enabled)
JWD Watch Dog Pins 1-2 (Reset)
Connector Description
COM1/COM2 COM1/COM2 Serial Port Connector/Header
FAN 1-5 Fan Headers 1-5
I-SATA0~SATA5 Intel (ESB2) SATA Ports
J22 Floppy Disk Drive Connector
JAR Alarm Reset
JD1 Power LED (pins1-3)/Speaker Header (pins 4-7)
JF1 Front Control Panel Connector
JIDE1 IDE Hard Drive Connector
JIDE2 Compact Flash Card Connector
JL1 Chassis Intrusion Header
JLAN1/2 Gigabit Ethernet Ports
JOH1 Overheat LED
JPW1 Primary 20-Pin ATX Power Connector
JPW2 Auxiliary Power Connector
JPW3 Processor Power Connector
JPWF Power Supply Fail Header
JUSB2/JUSB3 USB Headers (USB2/3 and USB4/5)
JWF1 Compact Flash Card Power Connector
JWOL Wake-on-LAN Header
JWOR Wake-on-Ring Header
SAS0~3, SAS4~7* SAS 0~3, SAS 4~7 Ports
SGPIO1/SGPIO2 SGPIO Headers
SIMSO IPMI 2.0 (with virtual media over LAN) Slot
SMB System Management Bus Header
SMBUS_PS System Management (I 2 C) Power Header
USB0/1 USB Ports
*X7DBR-3 only