Samsung BP59-00134G-01 - Manual (Page 42)

3-5 Using
Digital NR When a dotted line is displayed or the screen shakes, you can view a better visual quality picture by
enabling Noise Reduction.
When the input signal is PC Timing (D-Sub/HDMI), does not operate.
Black Level You can select the signal black level according to the input signal. If it is unsuitable for the input sig-
nal, the dark parts may appear clearly or may be dim.
The can only be set for the 480i and 576i RGB signals of [AV], [S-Video], and AV
Timing (D-Sub) modes.
• For [AV], [S-Video], and the 480i and 576i signals of AV Timing (D-Sub).
•
<0 IRE> : Sets the black level to <0 IRE>.
• <7.5 IRE> : Sets the black level to <7.5 IRE>.
• For the RGB signal of mode.
•
: Used in a normal environment.
• : Used when the dark part is shown too bright.
Overscan Using this function, you can cut the edge of the picture when unnecessary information or images
appear on the edge of the picture.
This is not supported in [AV] and [S-Video] modes.
This is supported only when the input signal is AV Timing (D-Sub) or AV Timing (HDMI).
If is turned off, unnecessary extra parts at the edges of an image may be shown.
In this case, turn on.
Film Mode Using this function, you can set the display mode optimized for playing movies.
• -
can only be supported for the [AV], [S-Video], 480i, and 576i of AV Timing (D-
Sub) signals.
PC Eliminates or reduces noise that causes unstable screen quality, such as screen shaking. If the noise
is not removed using Fine Adjustment, adjust the frequency to the maximum and then perform Fine
Adjustment again.
These functions are only enabled for the PC Timing (D-Sub/HDMI) input of the D-Sub terminal.
Refer to PC Timing (D-Sub/HDMI).
• : Used to adjust the frequency and phase of PC screen automatically.
• : Used to adjust the frequency when vertical lines appear on PC screen.
• : Used to fine tune the PC screen.
• : Using this function, you can reset the PC menu settings to the factory default settings.
Zoom Enlarges the PC screen to 2X, 4X, or 8X.
This function is only enabled when the input signal is PC Timing (D-Sub/HDMI).
MENU DESCRIPTION