Re fe re nces – Sharp XL-E80 User Manual

Page 29

XL-E80

nces

If trouble occurs

When this product is subjected to strong external interference
(mechanical shock, excessive static electricity, abnormal supply
voltage due to lightning, etc.) or if it is operated incorrectly, it may
malfunction.

If such a problem occurs, do the following:
1

Set the unit to the stand-by mode and turn the power on again.

If the unit is not restored in the previous operation, unplug and
plug in the unit, and then turn the power on.

Note:
If neither operation above restores the unit, clear all the memory by
resetting it.

Clearing all the memory (reset)

Caution:
This operation will erase all data stored in memory including clock,
timer settings, tuner preset, and CD program.

Condensation

Sudden temperature changes, storage or operation in an extremely
humid environment may cause condensation inside the cabinet (CD
pickup, tape heads, etc.) or on the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens,
leave the power on with no disc (or cassette) in the unit until normal
playback is possible (about 1 hour). Wipe off any condensation on
the transmitter with a soft cloth before operating the unit.

Care of compact discs

Compact discs are fairly resistant to damage, however mistracking
can occur due to an accumulation of dirt on the disc surface. Follow
the guidelines below for maximum enjoyment from your CD collec-
tion and player.

Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.

Keep your discs away from direct sunlight, heat, and excessive
moisture.

Always hold the CDs by the edges. Fingerprints, dirt, or water on
the CDs can cause noise or mistracking. If a CD is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight out
from the center, along the radius.

Press the ON/STAND-BY button to
enter the power stand-by mode.

While pressing down the MEMORY/
SET button and the TAPE

but-

ton, press the ON/STAND-BY button
until "CLEAR" appears.

YES
Correct