Sharp XL-E80 - Manual (Page 21)

21
XL-E80
T
a
p
e
P
lay
b
a
ck
Listening to a cassette tape
Before playback:
To stop playback:
Press the button.
Fast forward/rewind:
To advance the tape, press the
button. To rewind it, press the
button.
Caution:
" To remove the cassette, press the button, and then open the
compartment.
" Before changing from one tape operation to another, press the
button.
" If a power failure occurs during tape operation, the tape head will
remain engaged with the tape and the cassette compartment will
not open. In this case, wait until the power is restored.
" Even if the ( ) button is pressed during tape playback, the unit
will not enter the pause mode.
" For playback, use normal or low-noise tapes for
the best sound. (Metal or CrO tapes are not rec-
ommended.)
" Do not use C-120 tapes or poor-quality tapes, as they
may cause malfunctions.
" Before loading a tape into the cassette compartment,
tighten the slack with a pen or a pencil.
1 Press the ON/STAND-BY button to turn the power on.
2 Press the FUNCTION button until "TAPE" appears on the
display.
When operating with the remote control, press the TAPE but-
ton.
3 Open the cassette compart-
ment by pushing the area
marked "PUSH EJECT ".
4 Load a cassette into the cas-
sette compartment with the
side to be played facing to-
ward you.
5 Close the cassette compartment by pushing the area
marked "PUSH EJECT ".
6 Press the button to start
playback.
When playback is performed using the remote control, press
the
button.