Sennheiser 500 Series - Manual (Page 29)

Overview of the operating menus
27
Easy Setup Scans for unused frequency presets, releases and selects frequency presets
Frequency Preset Changes the frequency bank and the channel
Name Enters a freely selectable name
AF Out Adjusts the audio output level
Adjustment range: –24 dB to +24 dB, adjustable in 3-dB steps, 6 dB gain reserve
Special function “gain reserve”:
̈
When you have adjusted a level of +18 dB, turn the jog dial
²
to the right and keep it
in this position until the next higher value appears.
Equalizer Changes the frequency response of the output signal
Auto Lock Activates/deactivates the automatic lock mode
Advanced Calls up the extended menu “ Advanced Menu ”
Exit Exits the operating menu and returns to the current standard display
“Easy Setup”
Reset List Releases all locked frequency presets and selects an unused frequency preset
Current List Selects an unused frequency preset
Scan New List Scans for unused receiving frequencies (frequency preset scan)
Exit Exits the submenu “ Easy Setup ” and returns to the main menu
Extended menu “Advanced Menu”
Tune Sets the receiving frequencies for the frequency banks “ U1 ” to “ U6 ”
Special function: Sets a channel and a receiving frequency for the frequency banks “ U1 ” to
“ U6 ”:
̈
Select this menu item and call it up by pressing the jog dial
²
until the channel
selection appears.
Sync Settings Activates/deactivates the parameters to be transferred to the transmitters
Guitar Tuner Selects the mode of the guitar tuner function
Pilot Tone Activates/deactivates the pilot tone evaluation
Warnings Activates/deactivates the warning messages
LCD Contrast Adjusts the contrast of the display panel
Reset Resets the receiver
IP-Address Adjusts the IP address of the receiver
Software Revision Displays the current software revision
Exit Exits the extended menu “ Advanced Menu ” and returns to the main menu
Submenu “Sync Settings”
SKM Settings Activates/deactivates the parameters to be transferred to the SKM radio microphones
SK Settings Activates/deactivates the parameters to be transferred to the SK bodypack transmitters
Exit Exits the submenu “ Sync Settings ” and returns to the extended menu “ Advanced Menu ”
“SK Settings”/“SKM Settings”
Here you can activate/deactivate the transfer of the following transmitter parameters: Sensitivity, Auto Lock, Mute
Mode (SK), RF Power and Cable Emulation (SK) (see page 28)
“Warnings”
Activates/deactivates warnings (color change and warning messages):
AF-Peak Audio overmodulation
Low RF-Signal RF signal is weak
RF-Mute RF signal is too weak or no RF signal
Display Function of the menu item