Sennheiser 500 Series - Manual (Page 23)

Using the devices
21
To activate the RF signal :
Synchronizing a transmitter with the receiver
You can synchronize a suitable transmitter of the ew 500 G3 series with the receiver. During
synchronization, the following parameters are transferred to the transmitter:
To transfer the parameters:
̈
Switch the transmitter and the receiver on.
̈
Press the button
»
on the receiver.
“ Sync ” appears on the display panel of the receiver.
̈
Place the infra-red interface of the transmitter (see page 8 and page 10) in front of the
infra-red interface of the receiver
¿
.
The parameters are transferred to the transmitter. When the transfer is completed, “ ”
appears on the display panel. The receiver then switches back to the current standard
display.
To cancel the transfer:
̈
Press the STANDBY button on the receiver.
“ ” appears on the display panel of the receiver. “ ” also appears if:
– no transmitter was found or the transmitter is not compatible,
– no transmitter was found and the synchronization process was canceled after
30 seconds,
– you canceled the transfer.
̈
Press the multi-function switch
¸
.
The transmission frequency is displayed but the radio microphone does not
transmit an RF signal. The transmission icon
ብ
is not displayed. When the pilot
tone function is activated on both radio microphone and receiver, “ RF Mute ”
appears on the receiver’s display panel.
Use this function to save battery power or to prepare a radio microphone for use
during live operation without causing interference to existing transmission links.
̈
Briefly press the ON / OFF button
¹
.
“ RF Mute Off ” appears on the display panel.
̈ Press the multi-function switch ¸ .
The transmission icon
ብ
is displayed again.
MHz 543.200
ew500 G3
MUTE P
AF
ብ
SET
Setting Transferred parameters
“ Frequency Preset ” Currently set frequency
“ Name ” Freely selectable name currently set on the receiver
“ Pilot Tone ” Current pilot tone setting of the receiver (“ Inactive ”/“ Active ”)
¿
»
¿
»
Via the “ Sync Settings ” submenu, you can adjust the parameters to be transferred
to the transmitters (see page 27).