Sony Alpha 230 - Manual (Page 46)

46
Camera shake warning indicator
Note
• The (Camera shake warning) indicator is displayed only in the modes that
automatically set the shutter speed. This indicator is not displayed in M/S modes.
This SteadyShot function can reduce the effect of camera shake by the
equivalent of approximately 2.5 to 3.5 increments of shutter speed.
The SteadyShot function is set to [On] in the default setting.
The SteadyShot scale indicator
To deactivate the SteadyShot function
MENU button t 1 t [SteadyShot] t [Off]
Note
• The SteadyShot function may not work optimally when the power has just been
turned on or when the shutter button has been pressed all the way down without
stopping halfway. Wait for the
(SteadyShot scale) indicator scale to go down,
and then press the shutter button down slowly.
Due to potential camera shake, the
(Camera shake warning) indicator flashes
in the viewfinder. In this case, use a
tripod or the flash.
(Camera shake warning) indicator
Using the SteadyShot function
The (SteadyShot scale) indicator
shows the camera shake status. Wait until
the scale becomes low, then start
shooting.
(SteadyShot scale) indicator