Configuring bonding for multiple interfaces, To configure bonding for multiple ixgbe interfaces, To configure bonding for multiple ixgbe – Sun Microsystems 5945532 User Manual

Page 50

Sun Dual 10GbE SFP+ PCIe ExpressModule User’s Guide • August 2008

11. Click Subnet Mask.

The value 255.255.255.0 is displayed.

12. Click OK.

13. Repeat

Step 3

through

Step 10

until all the network ports are VLAN configured.

Note –

Ensure that the firewall is configured to allow VLAN traffic. Otherwise, the

VLAN might not operate properly.

Configuring Bonding for Multiple
Interfaces

▼

To Configure Bonding for Multiple ixgbe
Interfaces

1. Use the modprobe command to configure the mode:

In this command,

■

max_bonds

is the number of bond interfaces to be created.

■

mode

specifies the bonding policy. (This example uses balance-rr.)

2. Use the ifconfig command to create the bond:

In this command bond0 is the bonding device.

3. Configure the bond

n interfaces.

# modprobe bonding mode=balance-rr miimon=100 max_bonds=1

# ifconfig bond0 192.2.2.15 netmask 255.255.255.0 broadcast 192.2.2.255

# ifenslave bond0 eth4 eth5