JVC QP-F70AL - Manual (Page 4)

– 4 –
SP-XF30S SP-XF30F
Assembling the front and surround
speakers
Assembled speakers: With stand: Refer to Steps 1 to 6
Without stand: Refer to Steps 1 to 5
Before assembling—
• Prepare a Philips screwdriver (not supplied).
• Take care not to drop any component part while assembling;
otherwise, it may cause damage to the floor or injury.
• Each speaker cord has its name tag attached to one end. Attach the
end without the name tag to the speaker terminal.
Route the cord
Warnings, Cautions and Others
Precautions for installation
• Do not install the speakers on an uneven surface or in a place subject
to vibration; otherwise, they may fall over, causing damage or injury.
• The speakers are magnetically shielded to avoid color distortions on
TVs if they are installed properly.
– When placing the speakers near a TV set, turn off the TV’s main
power switch or unplug it before installing the speakers.
Then wait at least 30 minutes before turning on the TV’s main power
switch again. If there are still distortion, move the speakers further
away from the TV.
Precautions for daily use
• Do not reproduce sounds at so high a volume that they are distorted;
otherwise, the speakers may be damaged by internal heat buildup.
• When moving the speakers, do not pull the speaker cords; otherwise,
the speakers may fall over, causing damage or injury.
• When holding a speaker, always grasp the lower portion.
Checking the Components
Check to be sure you have the following components.
The number in parenthesis indicates the quantity of the piece supplied.
If any of the items above are missing, contact your dealer immediately.
6
5
4
3
2
• Speaker cords— 4 m (3): For front/center speakers
• Speaker cords— 10 m (2): For surround speakers
• Screws— M5 x 25 mm (8)
Surround
speakers (2)
Front
speakers (2)
Stands (4) Base plates (4)
1
Speaker cord
or or
Base plate
(Rear side)
With stand With stand Without stand Without stand
Surround back speaker (1) and
Speaker cord— 10 m (1)
Only for SP-XF70
Speaker cord
Stand
(or speaker
directly)
Base plate
Screw
(M5 x 25 mm)
Center speaker (1)
Press Release Insert
Black striped
Black
Copper
Speaker cord
Red
Stand
Speaker
White
Black
English
EN02-0 5 _SP-XF70_30[E] f f.p65 13/2/04, 7:45 PM 4