Sears 831.154020 - Manual (Page 15)

15
31. Attach the end of the Press Cable (109) to a “U”-
bracket (50) with an M8 Washer (98) and an M8
Nylon Locknut (91).
Note: Do not completely
tighten the Locknut; it should be tightened so
that only two threads of the Cable show past
the Locknut, as shown in the inset drawing.
33. Wrap the Butterfly Cable (106) over a “V”-pulley
(62). Attach the “V”-pulley, a Large Cable Trap
(111), an M10 Washer (99), and two Full Finger
Guards (104) to the Right Upright (2) with an M10
x 62mm Bolt (73) and an M10 Nylon Locknut
(90).
34. Wrap the Butterfly Cable (106) under a 90mm
Pulley (63). Attach the Pulley and two Half Finger
Guards (66) to the Double “U”-bracket (61) with
an M10 x 48mm Bolt (84) and an M10 Nylon
Locknut (90).
Make sure the Finger Guards are
oriented as shown.
35. Wrap the Butterfly Cable (106) over a “V”-pulley
(62). Attach the “V”-pulley, a Large Cable Trap
(111), an M10 Washer (99), and two Full Finger
Guards (104) to the Right Upright (2) with an M10
x 62mm Bolt (73) and an M10 Nylon Locknut
(90).
32. Locate the Butterfly Cable (106). Grease an M8
x 22mm Shoulder Bolt (39). Attach the Cable to
the Left Butterfly Arm (6) with the Bolt and an M8
Nylon Locknut (91).
Make sure the flat edge of
the Cable is against the Butterfly Arm.
31
32
33
34
35
50 91
98
109
39
91
6
106
Grease
Flat
Edge
90
90
66
66
61
84
2
104
104
106
106
111
62
73
99
63
90
2
104
104
106
111
62
73
99
91
109