Woodstock SHOP FOX W1747 - Manual (Page 34)

-32-
W1747 20" Planer
SE
RV
IC
E
7. Adjust the height of the infeed roller on the same
side as the Rotacator to the specification given at
the beginning of this procedure, using the zero set-
ting of the Rotacator as a reference point. Figure 27
shows the jam nut and set screw for adjusting the
roller height.
8. Repeat Steps 6–7 on the left-hand side of the infeed
roller.
9. Double-check and micro-adjust both sides of the
infeed roller, then carefully lock both sides in place.
10. Using the same zeroed reference on the Rotacator,
adjust the height of the outfeed roller, pressure bar,
and chip breaker to their given specifications. The
adjustment controls for each are shown in Figures
27, 28, and 29.
Figure 27. Roller height adjustment
controls.
Figure 28. Pressure bar height adjustment
controls.
Figure 29. Adjusting chip breaker height.
Jam
Nuts
Set
Screw
Infeed
Roller
Pressure
Bar
Adjustment
Location
Chip Breaker
Adjustment
Location
OFF
OFF
OFF
Outfeed
Roller
Set
Screw