Maintenance schedule cleaning & protecting – Southbend Turn-Nado EVS w/DRO SB1042PF User Manual

Page 68

MAINTENANCE

-66-

For Machines Mfg. Since 3/11

Turn-Nado

EVS Lathes

M A I N T E N A N C E

Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in electrocution or
accidental startup injury.

/&&

Maintenance Schedule

Cleaning & Protecting

Regular cleaning is one of the most important
steps in taking care of this lathe. We recommend
that the cleaning routine be planned into the
workflow schedule, so that adequate time is set
aside to do the job right.

Typically, the easiest way to clean swarf from
the bed ways and chip drawer is to use a wet/dry
shop vacuum that is dedicated for this purpose.
The small chips left over after vacuuming can be
wiped up with a slightly oiled rag. Avoid using
compressed air to blow off chips, as it may drive
them deeper into moving surfaces and could
cause sharp chips to fly into your face or hands.

Besides the ways, all other unpainted and
machined surfaces should be wiped down daily
to keep them rust-free and in top condition. This
includes any surface that is vulnerable to rust
if left unprotected (especially any parts that are
exposed to water-soluble coolant). Typically,
a thin ﬁlm of oil is all that is necessary for
protection.

For optimum performance from this machine,
this maintenance schedule must be strictly
followed. We strongly recommend all operators
make a habit of following the daily maintenance
procedures. Use the chart provided on Page 67
to ensure this is done.

Ongoing

The condition of machine components should be
carefully observed at all times to minimize the
risk of injury or machine damage. If any of the
conditions below are observed, stop the lathe
immediately, disconnect power, and correct the
condition before resuming operations:

,OOSE

7ORN

'UARDS

34/0

/IL

#OOLANT

Damaged or malfunctioning components.

Daily, Before Operations

#HECKADD

,UBRICATE

!DD

#LEANLUBRICATE

$ISENGAGE

%NSURE

Daily, After Operations

$EPRESS

6ACUUMCLEAN

7IPE

Monthly

$RAIN

Annually

#HANGE

,UBRICATE

#HECKLEVEL