Sony RDR-GX310 User Manual
Page 87

87
A
d
d
iti
o
n
a
l In
fo
rma
ti
o
n
The channel cannot be changed from the
channel you are recording.
, Set the TV’s input source to “TV.”
Recording does not start immediately after you
press
z REC.
, Operate the recorder only after “LOAD,”
“FORMAT,” or “INFOWRITE” disappears
from the front panel display.
Nothing was recorded even though you set the
timer setting correctly.
, There was a power failure during recording.
, The recorder’s internal clock stopped due to a
power failure that lasted for more than 1 hour.
Reset the clock (page 75).
, The channel was disabled after the timer
recording was set. See “Tuner Preset” on
page 74.
, Disconnect the AC power cord from an AC
outlet, and connect it again.
, The program contains copy protection signals
that restrict copying.
, The timer setting overlapped another setting that
was set later or has priority (page 47).
, There is no DVD inside the recorder.
, There is not enough disc space for the recording.
, The recorder was in the process of DV/Digital8
Dubbing.
Recording does not stop immediately after you
press
x REC STOP.
, It will take a few seconds for the recorder to input
disc data before recording can stop.
Recording does not stop after you press
x STOP.
, Open the remote’s cover and press x REC
STOP.
Timer recording is not complete or did not start
from the beginning.
, There was a power failure during recording. If
the power recovers when there is a timer
recording, the recorder resumes recording.
Should the power failure continue for more than
1 hour, reset the clock (page 75).
, The timer setting overlapped another setting that
was set later or has priority (page 47).
, Disc space was not enough.
Contents previously recorded were erased.
, Data that has been recorded on a DVD with a PC
will be erased from the disc when the disc is
inserted.
, The title was updated and recorded over
(page 41).
Nothing was recorded even though you set the
Synchro-Rec setting correctly.
, You forgot to turn off the connected equipment.
Turn off the connected equipment and set the
recorder to Synchro-Rec standby mode
(page 48).
, The recorder was not set to the Synchro-
Recording standby mode. Press SYNCHRO
REC to have the recorder stand by for recording.
Make sure the SYNCHRO REC indicator lights
up on the front panel (page 48).
, The recorder is connected to the TV output jack
of the connected equipment.
Synchro-Recording does not complete.
, The timer setting for the connected equipment
overlapped the recorder’s timer setting
(page 49).
, There was a power failure during the recording.
The recorder automatically starts recording
when the satellite receiver is turned on.
, The Synchro-Rec function was activated. Turn
off the satellite receiver and cancel the Synchro-
Rec function (page 48).
Recording/Timer recording/
Editing
Recording from the equipment
with a timer
,continued