JVC GR-D390EK - Manual (Page 31)

EN
31 ADDITIONAL FEATURES FOR D.S.C.
DIG
IT
A
L STILL C
A
MERA
(D
.S.C
.)
RECOR
D
IN
G & P
L
A
YBACK
3
Press , , or to
select “DPOF”, and press
SET. The DPOF Menu
appears.
4
Press or to select
“ALL 1”, and press SET or
. The DPOF screen
appears.
5
Press or to select
“EXECUTE”, and press
SET. The normal playback
screen appears.
● To cancel selection, select
“RETURN”.
To Print By Selecting Still Images And
Number Of Prints
1
Perform steps 1 – 3 in “To Print All Still
Images (One Print For Each)”. (
੬ pg. 30)
2
Press or to select
“CURRENT”, and press
SET or
. The DPOF
screen appears.
3
Press or to select
the desired file.
4
Press or to select the number indication
(00), and press SET.
5
Select the number of
prints by pressing to
increase the number, or
to decrease the number,
and press SET.
● Repeat steps 3 through 5
for the desired number of
prints.
● The number of prints can be set up to 15.
● To correct the number of prints, select the image
again and change the number.
6
Press or to select
“RETURN”, and press
SET. The “SAVE?”
appears.
● If you did not change any
settings in step 3 through
5, the DPOF Menu
reappears.
7
Press or to select “EXECUTE” to save
the setting you have just made, and press SET.
● To cancel selection, select “CANCEL”.
To Reset The Number Of Prints
1
Perform steps 1 – 3 in “To Print All Still
Images (One Print For Each)”. (
੬ pg. 30)
2
Press or to select “RESET”, and press
SET or . The DPOF screen appears.
3
Press or to select “EXECUTE”, and
press SET. The normal playback screen
appears.
● To cancel selection, select “RETURN”.
● The number of prints is reset to 0 for all still
images.
CAUTION:
While performing the above, never disconnect
power, as this may cause the memory card to be
corrupted.
You can initialise a memory card any time.
After initialising, all files and data stored in the
memory card, including those which have been
protected, are cleared.
1
Set the VIDEO/MEMORY Switch to
“MEMORY”.
2
Set the Power Switch to “PLAY” while
pressing down the Lock Button located on the
switch.
3
Press MENU. The Menu Screen appears.
4
Press , , or
to select “FORMAT”, and
press SET. The FORMAT
screen appears.
5
Press or to
select “EXECUTE”, and
press SET. The memory
card is initialised.
● When initialisation is finished, “NO IMAGES
STORED” appears.
● To cancel initialisation, select “RETURN”.
CAUTION:
Do not perform any other operation (such as
turning off the camcorder) during initialisation.
Also, be sure to use the provided AC Adapter, as
the memory card may be corrupted if the battery
becomes exhausted during initialisation. If the
memory card becomes corrupted, initialise it.
Initialising A Memory Card
F