This section shows the steps to set up the hardware which is explained
in Quick Install Guide. Make sure you read Quick Install Guide and
complete following steps.

Select a stable location.

Select a level, stable place with adequate space for air circulation.
Allow extra space to open covers and trays. Under the altitude
1,000 m (3,281 ft) is effective for printing. See the general settings
for Altitude Adjustment in page 3.5.

The area should be well-ventilated and away from direct sunlight or
sources of heat, cold, and humidity. Do not set the machine close to
the edge of your desk or table.

A horizontal plane must be within 5 mm (0.02 inches) both from front
to rear and from right to left.

Caution

• When you move the machine, do not tilt or turn it up side

down, or the inside of the machine may be contaminated by
toner, which can cause damage to the printer or bad printing
quality.

• If you are moving the machine or if machine is not in use for a

long time, turn on the power and wait until it goes in to the
ready mode. Then close the scan lid and turn the power off.
And open the scan lid and lock the scanner lock.

Unpack the machine and check all the enclosed items.

Remove the tape holding the machine tightly.

Install both the toner cartridges and imaging units.

Load paper. (See page 4.7 for "Loading paper")

Make sure that all the cables are connected to the machine.

Turn the machine on.

Setting up the network

You need to set up the network protocols on the machine to use it as your
network printer. You can set up the basic network settings with the
machine's touch screen.

Note

If you want to use the USB cable, connect the cable between a
computer and you machine. Refer to the software installation in
Software section.