Sunrise Medical F45 - Manual (Page 24)

20 F45 Issue 6
The Penny and Giles Pilot + control pod
Power supply
Ensure the power lead is connected
correctly into its socket on the rear of
the control pod (Fig. 27).
The immobiliser plug
When this is activated the chair will
not function, other than the hazard
warning light system. This may be
useful if you wish to leave your
wheelchair unattended (Fig. 27).
To activate the immobiliser
1. Switch the chair on via the On/
Off button (Fig. 28).
2. Insert the immobiliser plug into
the charger/programmer socket
located on the front of the control
pod.
3. Remove the plug after 1-2
seconds.
4. Your chair should now be
immobilised.
To de-activate the immobiliser
1. Switch the chair on via the On/
Off button (Fig. 28).
2. Insert the immobiliser plug into
the charger/programmer socket
located on the front of the control
pod.
3. Remove the plug after 1-2
seconds.
4. Your chair should now be ready
to use.
Fig. 27
Fig. 28
On/Off
button
Immobiliser
plug Charger /
programmer
socket