Sony SRP-X500P - Manual (Page 28)

SRP-X500P RS-232C Interface Manual
♦ OUTPUT MUTING (31st and 32nd byte)
Shows the muting status of the output channels.
The OUTPUT MUTING parameter consists of the 2 bytes of data in the order shown in the following
table.
Byte Parameter
1st SPEAKER OUTPUT MUTING
2nd LINE OUTPUT MUTING
• SPEAKER OUTPUT MUTING
Shows the muting status of the speaker output channels in the form of 8 bits of data.
The bit is 0 for a channel which is not turned off (
“ Muting off”) and 1 for a channel which is
turned off ( “ Muting on”).
MSB LSB
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
0 1 0 0 CH4 CH3 CH 2 CH 1
• LINE OUTPUT MUTING
Shows the muting status of the LINE OUTPUT channels in the form of 8 bits of data.
The bit is 0 for a channel which is not turned off (
“ Muting off”) and 1 for a channel which is
turned off ( “ Muting on”).
MSB LSB
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
0 1 0 0 CH4 CH3 CH 2 CH 1
♦ MASTER MUTING (33rd byte)
Shows the muting setting of the master volume.
The parameter and the muting setting are as shown in the following table.
MUTING
Muting off 0x30(‘0’)
Muting on 0x31(‘1’)
♦ REMOTE MUTING (34th byte)
Shows the muting status of the REMOTE 1-6 faders in the form of 8 bits of data.
The bit is 0 for a channel which is not turned off (
“ Muting off”) and 1 for a channel which is turned
off ( “ Muting on”).
MSB LSB
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
0 1 CH 6 CH 5 CH4 CH3 CH 2 CH 1
Page 28/43