Siemens BACnet ATEC 125-5050 - Manual (Page 7)

How To Use This Manual
7
Siemens Industry, Inc. BACnet ATEC Owner's Manaul
125-5050, Rev. AA 4/20/2010
How To Use This Manual
This manual is written for the owner and user of the Siemens Industry BACnet VAV
Actuator. It is designed to help you become familiar with the Siemens BACnet VAV
Actuator and its applications.
This section covers manual organization, manual conventions, symbols used in the
manual, and other information that will help you use this manual.
Manual Organization
This manual contains the following chapters:

Chapter 1, Hardware, describes the hardware components and the accessories
that are used with the BACnet VAV Actuator.

Chapter 2, Applications for BACnet VAV Actuator, describes the control
applications available in the model of the BACnet VAV Actuator that includes a
terminal block for wireable input/output connections.

Chapter 3, Point Database, defines the point database descriptors and includes
address and applications.

Chapter 4, Troubleshooting, describes basic corrective measures you can take
should you encounter a problem when using the BACnet VAV Actuator. For issues
not covered in this chapter, consult your local Siemens Industry representative.
 The Glossary describes the terms and acronyms used in this manual.

The Index helps you locate information presented in this manual.
Manual Conventions
The following table lists conventions to help you use this manual in a quick and
efficient manner.
Convention Examples
Numbered Lists (1, 2, 3…) indicate a
procedure with sequential steps.
1. Turn OFF power to the field panel.
2. Turn ON power to the field panel.
3. Contact y the local Siemens Building
Technologies representative.
Conditions that must be completed or met
before beginning a task are designated with a
⊳.
Intermediate results (what will happen
following the execution of a step), are
designated with a ⇨.
Results, which inform the user that a task was
completed successfully, are designated with a
⇨.
⊳Composer software is properly installed.
⊳A Valid license is available.
1. Select Start > Programs > Siemens > GMS
> Composer.
⇨The Project Management window displays.
2. Open an existing project or create a new
one.
⇨The project window displays.
Actions that should be performed are specified
in boldface font.
Type F for Field panels.
Click OK to save changes and close the