Siemens BACnet ATEC 125-5050 - Manual (Page 23)

Chapter 2 – Applications
23
Siemens Industry, Inc. BACnet ATEC Owner's Manaul
125-5050, Rev. AA 4/20/2010
DO 3, DO 4, and DO 5 may be used as separate DOs or in pairs to control a motor as
shown in the example.
NOTE:
If using either a motor or DOs as auxiliary points, be sure to set MTR SETUP to
the correct value. If using a pair of DOs to control a motor, then the DOs cannot
be unbundled. Only MTR COMD can be unbundled to control the motors.
Contact your local Siemens Industry representative for other combinations of DOs and
motors.