Smart Technologies SBID Interactive Display 6052i - Manual (Page 42)

34 | CHAPTER 5 – TROUBLESHOOTING
To remove a
persistent image
1. Turn off the interactive display and the computer.
2. Leave the interactive display and the computer off for the same length of time as
the persistent image was on-screen. For example, if the interactive display
displayed an image for one hour and a residual image remains, don’t turn on the
computer and the interactive display until after a minimum of one hour.
Troubleshooting Unstable or Unfocused Images
Complete the following steps if your LCD screen displays an unstable or unfocused
image.
To troubleshoot
unstable or unfocused
image issues
1. Turn off the interactive display, and then turn off the computer.
2. Disconnect the video cable that connects the interactive display’s bottom terminal
panel to the computer.
3. Connect the video cable from the interactive display’s bottom terminal panel to the
computer.
4. Turn on the interactive display, and then turn on the LCD monitor.
5. If the LCD monitor still displays an unstable or unfocused image, open the
on-screen menu, and then change the image settings in the Adjust sub-menu. If
this resolves the issue, you could need to change the image settings again the
next time you change display modes.
Troubleshooting Resolution Issues
To troubleshoot
resolution issues
Open the on-screen menu, and adjust the resolution. For more information, see
Wireless Remote Control Buttons on page 25.
For additional troubleshooting suggestions, see the NEC MultiSync S521 User’s
Manual (
document 145185 ).