Smart Technologies SBID Interactive Display 6052i - Manual (Page 33)

25 | CHAPTER 4 – USING THE INTERACTIVE DISPLAY
Wireless Remote Control Buttons
The table below explains the function of the most commonly used buttons.
To use the wireless
remote control
Point the top of the remote control toward the wireless remote control sensor when
you press the buttons.
Use the remote control within approximately 23' (7 m) of the remote control sensor or
at a horizontal and vertical angle of 30° within a distance of about 10' (3.5 m).
POWER ON Switches the power on/standby
Input buttons (8) Selects input signal for the display. Choose
from DVI, DISPLAY PORT, VGAM, RGB/RV,
HDMI, DVD, VIDEO or S-VIDEO
PICTURE MODE Selects picture mode
ASPECT Selects picture aspect
SOUND Selects artificial surround sound
Number pad Press buttons to set and change passwords,
change channel and make settings
DISPLAY Turns the on-screen display menu on and off
MENU Turns the menu mode on and off
AUTO SET UP Enters auto setup menu
UP/DOWN Acts as button to move the highlighted area up
or down to select adjustment items within the
on-screen display menu
+/- Increases or decreases the adjustment level
within the on-screen display menu
SET Makes selection
VOL +/- Increases or decreases audio output level
IMPORTANT
You must add speakers to the interactive
display to have audio output.
CH +/- Changes the channel for the interactive display
For other buttons, see the NEC MultiSync® S521 User’s Manual
(
document 145185 ).