Southbend SB1049 - Manual (Page 23)

For Machines Mfg. Since 5/11 13" Heavy 13 ® Gearhead Lathe
-21-
P R E P A R A T I O N
Children or untrained
people may be seriously
injured by this machine.
Install machine in an
access restricted location.
Space Allocation
Consider the largest size of workpiece that will
be processed through this machine and provide
enough space around the machine for adequate
operator material handling or the installation
of auxiliary equipment. With permanent
installations, leave enough space around
the machine to open or remove doors/covers
as required by the maintenance and service
described in this manual.
Weight Load
Refer to the Machine Specifications for the
weight of your machine. Make sure that the
surface upon which the machine is placed will
bear the weight of the machine, additional
equipment that may be installed on the machine,
and the heaviest workpiece that will be used.
Additionally, consider the weight of the operator
and any dynamic loading that may occur when
operating the machine.
Physical Environment
The physical environment where your machine
is operated is important for safe operation and
longevity of parts. For best results, operate this
machine in a dry environment that is free from
excessive moisture, hazardous or flammable
chemicals, airborne abrasives, or extreme
conditions. Extreme conditions for this type
of machinery are generally those where the
ambient temperature is outside the range of 41°–
104°F; the relative humidity is outside the range
of 20–95% (non-condensing); or the environment
is subject to vibration, shocks, or bumps.
Electrical Installation
Place this machine near an existing power source
that meets the minimum circuit requirements.
Make sure all power cords are protected from
traffic, material handling, moisture, chemicals,
or other hazards. Leave access to disconnect the
power source or engage a lockout/tagout device.
Lighting
Lighting around the machine must be adequate
enough that operations can be performed
safely. Shadows, glare, or strobe effects that
may distract or impede the operator must be
eliminated.
Location Location
Figure 12. Space required for full range of movement.
Keep
Workpiece
Loading Area
Unobstructed
Lathe
Electrical
Cabinet
Wall
(Drawing Not To Scale)
79" (SB1049)
90" (SB1050)
54"
Min. 30"
for Maintenance
38"