SATO MB400 User Manual
Page 5
MB400
Quick
Guide
Pg
17
Status
(LED)
Mode Details
Cause Solution
Green
(blinking)
On-Line
(Printing
/Receiving
data)
Buffer near full
Approaching the
buffer quota
Pause the data
transmission
and wait till the
buffer is empty
before trying
again.
Red
(blinking)
All Modes
Low Battery
Batteries are not
recharged
properly.
Recharge the
batteries.
The power will automatically be turned off 30 seconds after “Low Battery” is indicated. Make
sure the power is off before removing the battery pack and recharge the battery.
MB400
Quick
Guide
Pg
2
Installation
Remove the MB400 from its packing container. Check to make sure you have the following
items:
Other Accessories
• Cable Lock - Attached to the interface connector.
• Adjustment Screwdriver - Located inside the printer (under
the label feed area).
Quick Guide
Shoulder belt
Battery pack
Printer
* The shape of the protector
pads to hold the printer in place
may differ from the picture
shown.