Siemens optipoint 200 - Manual (Page 18)

18
Gigaset 200, GBR, A31008-G200-B101-1-7619 BASISST.FM 28.09.01
Settings of the base unit
Normally, no changes are necessary to settings in the
base unit.
Settings in the base unit can be easily changed by
using the mobile part if necessary.
Prerequisite:
The handset must be registered with the base unit.
Signaling method
You use this function to change to the pulse signaling
method.
Factory default: Multifrequency signaling method.
Press the off-hook key.
The following appears on the
display
.
Open the menu.
DIAL MODE Confirm.
3
PULSE Select and confirm your desired
signaling method
or
TONE select and confirm.
Press the on-hook key.
Flash times („R key“)
This function allows you to change the set flash time
(factory default see page 20).
Press the off-hook key.
Open the menu.
3
TBR Select and confirm.
3
180 MS Select and confirm the desired
flash time (80, 100, 120, 180,
250, 300 or 600 ms).
Press the on-hook key.
" "
8
If you hold down the
4
key, you automati-
cally have multifrequency signaling for the
subsequent call.