Sharp AQUOS 09P09-MX-NM - Manual (Page 15)

13
Connecting to External Equipment
Connecting a Speaker/Amplifi er
■ When using optical fi ber cable:
It is possible to output audio through the DIGITAL AUDIO OUTPUT
terminal. (See page 31 for details.) PCM audio outputs from the terminal.
• Depending on the connected equipment, audio will not output from the DIGITAL AUDIO OUTPUT terminal in HDMI
connection. In this case, set the audio formats of the connected equipment to PCM, 32/44.1/48 kHz.
■ When using audio cable:
Connecting a PC
Refer to page 40 for a list of PC signals compatible with the TV.
■ When using HDMI cable (INPUT 5, 6, 7 or 8):
• Depending on the board, only video signals may be output. In this case, in addition to connecting an HDMI-certifi ed cable to the
INPUT 6 (HDMI) terminal, connect an audio cable to the AUDIO terminal and set "PC Audio Select" to "Input 6 (HDMI)". (See page 40.)
• The HDMI terminals only support digital signal.
DIGITAL AUDIO INPUT
OPTICAL
Rear of the TV
Optical fi ber cable
DIGITAL AUDIO INPUT
OPTICAL
Rear of the TV
Optical fi ber cable
ANALOG AUDIO IN
Rear of the TV
AUDIO-R (Red)
AUDIO-L (White)
Audio cable
ANALOG AUDIO IN
Rear of the TV
AUDIO-R (Red)
AUDIO-L (White)
Audio cable
HDMI OUT
Rear of the TV Side Panel
HDMI-certifi ed cable
HDMI OUT
Rear of the TV Side Panel
HDMI-certifi ed cable