SanDisk e200 User Manual
Page 8
Sansa_e200_UserManual.doc
7
Charging
Please execute the following instructions for charging the battery using
an USB port.
1) Connect the smaller end of the USB cable into an available USB
port on the computer
2) Connect the larger end of the USB cable into the dock connector of
the player
3) The computer must be on for most USB ports to charge your
battery. Your Sansa will show connected and the yellow charging
indicator will appear. The battery level indicator will blink while
charging. You will not be able to play while connected to the
computer USB.
4) To stop recharging, disconnect the cable.
The battery can also be charged using an AC adapter (not included) or
a car adapter (not included) and you will be able to play your device
while charging with one of the adapters. The battery will reach
approximately 70% charge in 2.5 hours and full charge in about 3.5
hours. It is recommended that you fully charge your Sansa e200
before the first use.
Note: Some low-power USB ports may not be able to provide enough
charge power. Also note that rechargeable batteries may
eventually need to be replaced as they have limited charge
cycles (which vary with use and settings).
Level Indicator
Battery is Half Full
Battery is Low
Replacement
The Li-ion rechargeable battery is replaceable. To purchase a
replacement battery, visit your local retailer or
www.sandisk.com
.
Follow the instructions provided with the replacement battery.
Warning
CAUTION
:
Do not disassemble, crush, short-circuit or incinerate
your battery as it may cause fire, injury, burns or other hazards