Samsung Eternity II SGH-A597 - Manual (Page 164)

159
• Auth Type: select the type of authentication used for this WAP
connection: None, Normal, or Secure.
• User ID: enter the User ID required to connect to the network.
• Password: enter the user password required to connect to the
network.
• Protocol: set the connection protocol used by the WAP browser:
WAP or HTTP.
• Home URL: enter the URL address of the page to be used as your
homepage.
• Gateway Address: (WAP only) enter the gateway address of the
proxy server.
• Proxy Address: (HTTP only) set the proxy server address and port.
• Secure Connection: (WAP only) determines if the connection
follows a secure protocol. Select On or Off.
• Linger Time (sec.): set a time period (in seconds) after which the
network is disconnected if there has been no new data traffic in that
time.
• Advanced Settings: (touch ) allows you to configure some of
the IP-specific information: Static IP, Static DNS, Server information,
and Traffic Class.
– Static IP: specify if you want to manually enter an IP address. If you
want the IP address to be automatically assigned by the server, remove
the check mark.
– Local Phone IP: enter the IP address obtained from the network
operator, if you checked the Static IP option.
– Static DNS: specify if you want to manually enter the Domain Name
Server (DNS) address. If you want the address to be automatically
assigned by the server, remove the check mark.
– Server 1/Server 2: enter the Domain Name Server (DNS) addresses.
– Traffic Class: select the traffic class.
4. Touch to save these settings.
The WAP settings may vary depending on the service provider.
Save