Sharp SRT-8040 - Manual (Page 47)

OUTPUT TERMINALS
SW OUT Terminal
When recording, a pulse signal is output at the SW OUT
terminal.
This terminal is usually connected to the switch input
(SW IN) of devices like a camera switcher unit, or a quad
compressor.
SW OUT Terminal Output Setting
1 Press the MENU button to display the MAIN MENU.
2 Turn the JOG dial to select the “2.DISPLAY/SW
OUT SET” line, then turn the SHUTTLE ring
clockwise.
ø The (DISPLAY/SW OUT SET) menu appears.
@@@@SET@UP
DATE@@@@@@@@@@@@@Y
TIME@@@@@@@@@@@@@Y
SPEED@@@@@@@@@@@@Y
ALARM@COUNT@@@@@@Y
TIMING@@@@@@@@@@@FIELD
FIELD@@@@@@@@@@@@1
8H@MODE@@@@@@@@@@Y
3 Turn the JOG dial until the “TIMING” setting is
highlighted, then turn the SHUTTLE ring clockwise.
4 Turn the JOG dial to select the desired output timing,
then turn the SHUTTLE ring clockwise.
FIELD. . . . . . 1 pulse is output after each set
number of fields.
FRAME . . . . 1 pulse is output after each set
number of frames.
5 Turn the SHUTTLE ring clockwise.
6 Turn the JOG dial to select the desired pulse signal
interval (1, 2, 3, 4, 5, 10, 30 or 60), then turn the
SHUTTLE ring clockwise.
œ If “TIMING” is set to FRAME (see step 4 ),
“FRAME” will be indicated instead of “FIELD”.
7 Turn the SHUTTLE ring clockwise.
8 Turn the JOG dial to select the desired “8H” (or
“6H”) mode, then turn the SHUTTLE ring clockwise.
œ If the “TAPE” in the (GENERAL SET) menu is set
to “T-120”, “6H” will be indicated instead of “8H”.
Y. . . . . . . . . . When recording in 8-hour (or
6-hour) mode, a pulse signal is
output.
N. . . . . . . . . . When recording in 8-hour (or
6-hour) mode, a pulse signal is
not output.
9 Press the MENU EXIT button.
5V (H)
0V (L)
(Output impedance: 5.7 k
Ω
)
FIELD: 16.7 msec.
FRAME: 5 msec.
RF4QR/NA (SRT-8960 GB) Wed. May, 08/2002
46
English