Sharp SRT-8040 - Manual (Page 16)

VIDEO CASSETTE TAPES
Correct tape thread check function
This function checks to make sure that the cassette has
been correctly loaded so that recording can be carried
out.
NOTES:
œ After the cassette tape is loaded, the mechanism will
operate for about 5 seconds to check that the tape
has been threaded (loaded) correctly automatically
and the cassette indicator “
o ” will flash during that
period. If the tape is not loaded properly, the cassette
will be ejected.
œ If the REC, PLAY or STOP button is pressed or if the
SHUTTLE ring is turned during the tape thread check
operation, the command will only be executed after
the tape thread has been checked. Only the EJECT
button will operate while the tape thread is being
checked.
œ If “TAPE IN MODE” in the (GENERAL SET) menu is
set to “REC”, the recording indicator “
m ” will light while
the tape thread is being checked. However, recording
will only start after the tape thread check is completed.
1 Press the MENU button to display the MAIN MENU.
2 Turn the JOG dial to select the “3.GENERAL SET”
line, then turn the SHUTTLE ring clockwise.
ø The (GENERAL SET) menu appears.
TAPE@IN@MODE@@@@@STOP
TAPE@END@MODE@@@@REW
CLOCK@ADJUST@@@@@01:00
THREAD@CHECK@@@@@N
VIDEO@LOSS@@@@@@@N
CLOG@DETECT.@@@@@N
REMOTE@@@@@@@@@@@MENU
VIDEO@@@@@@@@@@@@COLOR
VERTICAL@SYNC@@@@Y
TAPE@@@@@@@@@@@@@T-160
3 Turn the JOG dial until the “THREAD CHECK”
setting is highlighted, then turn the SHUTTLE ring
clockwise.
4 Turn the JOG dial to select the desired mode, then
turn the SHUTTLE ring clockwise.
N . . . . . . . . . The correct tape thread check
function is off
Y. . . . . . . . . . The correct tape thread check
function is on
5 Press the MENU EXIT button.
Setting the Action to Take When a
Cassette is Loaded
You can set the mode the VCR will go into when a
cassette is loaded.
1 Press the MENU button to display the MAIN MENU.
2 Turn the JOG dial to select the “3.GENERAL SET”
line, then turn the SHUTTLE ring clockwise.
ø The (GENERAL SET) menu appears.
3 Turn the JOG dial until the “TAPE IN MODE” setting
is highlighted, then turn the SHUTTLE ring clockwise.
4 Turn the JOG dial to select the desired mode, then
turn the SHUTTLE ring clockwise.
STOP . . . . . . When tape inserted the VCR,
stays in stop mode
REC . . . . . . . When tape inserted the VCR,
goes into recording mode
5 Press the MENU EXIT button.
Setting the Type of Tape Used
1 Press the MENU button to display the MAIN MENU.
2 Turn the JOG dial to select the “3.GENERAL SET”
line, then turn the SHUTTLE ring clockwise.
ø The (GENERAL SET) menu appears.
3 Turn the JOG dial until the “TAPE” setting is
highlighted, then turn the SHUTTLE ring clockwise.
4 Turn the JOG dial to set the tape length, then turn
the SHUTTLE ring clockwise.
T-160 . . . . . . When using a T-160 cassette tape
T-120 . . . . . . When using a T-120 cassette tape
5 Press the MENU EXIT button.
RF4QR/NA (SRT-8960 GB) Wed. May, 08/2002
English
15