Sharp SRT-8040 - Manual (Page 23)

NORMAL RECORDING
Setting the Mode at the End of the Tape
You can select the mode on the VCR when the tape
reaches the end during recording.
1 Press the MENU button to display the MAIN MENU.
2 Turn the JOG dial to select the “3.GENERAL SET”
line, then turn the SHUTTLE ring clockwise.
ø The (GENERAL SET) menu appears.
TAPE@IN@MODE@@@@@STOP
TAPE@END@MODE@@@@REW
CLOCK@ADJUST@@@@@01:00
THREAD@CHECK@@@@@N
VIDEO@LOSS@@@@@@@N
CLOG@DETECT.@@@@@N
REMOTE@@@@@@@@@@@MENU
VIDEO@@@@@@@@@@@@COLOR
VERTICAL@SYNC@@@@Y
TAPE@@@@@@@@@@@@@T-160
3 Turn the JOG dial until the “TAPE END MODE”
setting is highlighted, then turn the SHUTTLE ring
clockwise.
4 Turn the JOG dial to select the desired mode, then
turn the SHUTTLE ring clockwise.
œ Setting when not using Autorepeat recording
REW. . . . . . . Rewinds the tape to the
beginning, then goes to stop mode
STOP . . . . . . Goes to stop mode
EJECT . . . . . The cassette is ejected
œ Setting when using Autorepeat recording
REPEAT1. . . Autorepeat recording mode is
automatically canceled if there
was an alarm trigger
REPEAT2. . . Autorepeat recording mode is
active even if there was an alarm
trigger
5 Press the MENU EXIT button.
Setting the video input signal
The video input signal during recording can be set to
either color or black & white.
1 Press the MENU button to display the MAIN MENU.
2 Turn the JOG dial to select the “3.GENERAL SET”
line, then turn the SHUTTLE ring clockwise.
3 Turn the JOG dial until the “VIDEO” setting is
highlighted, then turn the SHUTTLE ring clockwise.
4 Turn the JOG dial to select the desired mode, then
turn the SHUTTLE ring clockwise.
COLOR . . . . For recording in color
B/W . . . . . . . For recording in black & white
5 Press the MENU EXIT button.
NOTES:
œ Set to “COLOR” for systems which include color
signals (including cases where black & white signals
are mixed in), and set to “B/W” for systems which only
use black & white signals.
œ Use the same setting for recording and playback.
œ If tapes that have been recorded in black & white are
played back when the setting is at “COLOR”, the
recordings will not be played back in color.
œ
If using a black & white camera, set to “B/W”.
Recordings will not be made in color even if “COLOR”
is set.
RF4QR/NA (SRT-8960 GB) Wed. May, 08/2002
22
English