Operating the handset, Inserting the batteries – Siemens Gigaset 4210 User Manual
Page 10
4
Setting Up the Telephone
Gigaset 4015 Comfort, USA, A31008-G4015-B102-1-7619
vorberei.fm
24.08.01
Operating the Handset
Inserting the Batteries
●
Insert the batteries, as shown above.
●
Place cover and push gently upward until it clicks into place (the unit
is shipped with the battery cover off).
●
To open, press the grooved area on the cover and slide back.
Placing Handset into the Base Station and Charging the
Batteries
Turn the handset off by holding down the END key then place it in the
base station with the display facing upward toward you. After about
one minute, the handset's internal number will appear on the display
(for example“INT 1”). Successful registration is signaled by a confir-
mation beep (crescendo tone sequence).
The display is protected by a plastic film.
Remove the protective plastic film!
●
Use only “AA” rechargeable NiCd or NiMH batteries. Do not
use Alkaline, Lithium or non-rechargeable batteries.
●
Never use non-Siemens charging units as these can damage
the batteries.
IMPORTANT! Before using your handset, you must register it
first.
For information on how to register additional handsets (bought
separately), see page 38.
+
–
+
–
G