Sharp MD-M3H - Manual (Page 9)

7
(Continued)
■ Removing the speaker grilles ■ Connecting the AC power lead
Connect the AC power lead to the AC INPUT socket,
then connect the AC power lead plug to an AC
socket.
Notes:
● Unplug the AC power lead from the AC socket if
the unit will not be in use for a prolonged period
of time.
● Never use a power lead other than the one sup-
plied. Use of a power lead other than the one
supplied may cause an electric shock or fire.
■ Demo mode
10 cm (4") 10 cm (4")
20 cm (8")
10 cm (4")
DEMO
ON
OFF
To an AC socket
To AC INPUT
AC 230 V, 50 Hz
AC INPUT
When the AC power lead is first connected, the unit
will enter the demonstration mode and the words
will scroll across the display continuously.
To cancel the demonstration mode:
When in the demonstration mode, set the DEMO
switch to OFF.
Then turn the power on and enter the stand-by
mode to cancel the demonstration mode and to
enter the low power consumption mode.
Note:
● When the unit is in the low power consumption
mode, the display will disappear.
To return to the demonstration mode:
Set the DEMO switch to ON. Then turn the power
on and enter the stand-by mode.
1
Remove the lower part of the speaker grille first.
2
Remove the upper part of the speaker grille.
Caution:
When the speaker grilles are removed, the speaker
diaphragms are exposed. Make sure nothing comes
into contact with the speaker diaphragms.
■ Speaker cushion
Attach the cushions to the bottom of the speaker to
prevent it from sliding.
■ Placing the system
● Be sure to keep space between the units for ven-
tilation.
● Keep the top of this unit at least 20 cm (8") away
from the wall, and the back at least 10 cm (4")
away.
Note:
● Do not place the system or speakers near the
television set as the magnetic fields produced
may cause irregular colours to be displayed.