Sharp MD-M3H - Manual (Page 49)

47
When an error message is displayed, proceed as follows:
Error messages
BLANK MD
CAN’T EDIT
CAN’T REC
CD NO DISC
DISC FULL
FOCUS ERR
MD ERR
MD NO DISC
MECHA ERR*
(*:Number or
symbol)
NAME FULL
NOT AUDIO
PLAYBACK MD
PROTECTED
READ ERR
TEMP OVER
TOC ERR*
(*:Number or
symbol)
TOC FULL*
(*:Number or
symbol)
TOC W ERR
U TOC ERR*
(*:Symbol)
U TOC ERR W
? DISC
00:00
Remedy
● Replace it with another disc.
● Change the stop position of the track and
then try editing it.
● Re-record or replace the MiniDisc.
● Replace it with another disc.
● Load a CD.
● Reload the CD.
● Replace the disc with another recordable
disc.
● Reload the MiniDisc.
● Contact the shop where you purchased the
unit.
● Load a MiniDisc.
● Reload the MiniDisc.
● Set this unit to the stand-by mode and press
the MD EJECT button.
● Shorten the disc or track name.
● Select another track.
● Replace the disc.
● Replace it with another recordable disc.
● Move the write protection tab back to its
original position.
● Reload the disc or replace it.
● Set this unit to the stand-by mode and wait
for a while.
● Replace it with another disc.
● Replace it with another recordable disc.
● Contact the shop where you purchased the
unit.
● Replace it with another disc.
● Erase all of the track, and try recording.
● Set this unit to the stand-by mode and try to
write the TOC again. (Remove any source
of shock or vibration whilst writing.)
● Replace it with another disc.
● Replace the disc with another recordable
disc.
Meaning
● Nothing is recorded.
● A track cannot be edited.
● Recording cannot be performed correctly
due to vibra-tion or shock in the unit.
● Timer recording is impossible or there is no
available space on the MD.
● A CD has not been loaded.
● The disc data cannot be read.
● The disc is out of recording space.
● A disc has not been loaded.
● The disc data cannot be read.
● Trouble is found.
● A MiniDisc has not been loaded.
● The disc data cannot be read.
● The disc data cannot be read.
● There is a mechanical problem and the disc
is not working properly.
● The number of characters for the disc name
or track name exceeds 40.
● The data recorded on this disc is not audio
data.
● You tried to record on a playback-only disc.
● The disc is write protected.
● The disc is damaged.
● A TOC is not written on the MD or there is
something wrong with data.
● The temperature is too high.
● The disc is damaged.
● TOC information cannot be read.
● MD not specified.
● There is no space left for recording charac-
ter information(track names, disc names,
etc.).
● Recording is impossible.
● TOC information recorded on the MD does
not match the MD specifications or it can-
not be read.
● The TOC information could not be created
properly due to a mechanical shock or to
scratches on the disc.
● The data contains an error.
● Music is not being recorded.
ERROR MESSAGES