Sharp MD-M3H - Manual (Page 26)

24
PRESET(
X W
)
PRESET(
X W
)
(Continued)
■ To manually recall the stations
stored in memory
■ To switch the display
Each time the DISPLAY MODE button is pressed
whilst an FM station is tuned in, the display will
switch as follows:
MHz
Radio text
(RT)
Programme
type (PTY)
Station
name (PS)
Frequency
Each time you press the PRESET (
X
or
W
) button
the channel number will change.
● After the channel number has been displayed for
2 seconds, the frequency for that channel will
appear for 2 seconds, and then the station name
will appear.
DISPLAY
MODE
(Main unit operation)
When the station you are tuning in is not an RDS
station or even if it is an RDS station but it is very
weak signal, the display will change in the follow-
ing order:
MHz
Frequency
■ Notes for Radio text
● The radio text for 10 characters will be displayed
steadily for 4 seconds and then it will scroll across
the display.
● If you tune into a station which is not broadcast-
ing any radio text, even if it is an RDS station,
when you switch to the radio text position "NO
RT" will be displayed.
● Whilst radio text data is being received or when
the text contents change, "RT" will be displayed.
■ Notes for RDS operation
If any of the following events occur, it does not mean
that the unit is faulty.
● "PS", "NO PS" and a station name appear alter-
nately, and the unit does not operate properly.
● If a particular station is not broadcasting prop-
erly or a station is conducting tests, the RDS re-
ception function may not work properly.
● When you receive an RDS station whose signal
is too weak, information like the station name may
not be displayed, even if "RDS" is lit.
Notes:
● "NO PS", "NO PTY" or "NO RT" will flash for
about 5 seconds, and then the frequency will be
displayed.
● The display can only be switched whilst tuned to
the FM band.