Sharp MD-M3H - Manual (Page 24)

22
To try to store a station name again, if the
wrong name was stored in memory by mis-
take:
When you store station names in memory using
the ASPM function, the correct station names may
not actually be stored if there is lots of noise or if
the RDS station signal is too weak.
In this case, try storing station names in memory
using the following procedure.
Notes:
● When there are no station names stored in
memory, you cannot use this function. In this
case, when the STATION button is pressed,
"NOTHING" will flash for 5 seconds, and the unit
will return to the original display.
● This function can only be used when the FM band
has been selected.
● The same station name can be stored in differ-
ent preset channels. Therefore, when you are
choosing a station name from the presets, the
same station name may be encountered more
than once.
● In a certain area or during certain time periods,
the station names selected using the station se-
lect function may temporarily be different from
the name of the station you are actually receiv-
ing.
(Continued)
2
1,3
4,5 2
1,3
4,5
1
Press the STATION button.
2
Within 6 seconds, press the PRESET (
X
or
W
)
button to check whether the station names are
correct.
3
If you find a station name that is wrong, press
the STATION button again within 6 seconds to
recall the preset station, which corresponds to
the station name.
4
After the preset station has been received and
the correct station name has been displayed,
press the MEMORY button.
5
Within 5 seconds, Press the MEMORY button
again whilst the preset channel number is flash-
ing.
● The new station name has been stored in
memory correctly.