Sharp Aquos TINS-E595WJQZ - Manual (Page 25)

23
Connection and Setup
Speaker Connections
Connecting speaker wires
Make sure to leave the AC power lead disconnected when connecting the speakers.
To prevent accidental short circuit between m and n terminals, connect the speaker wires to the speakers first then to the
main unit.
Connect the wires to the speakers.
Red Black
Speaker terminals
Red
Black
1
Connect the other end to the main unit.
2
CAUTION
The supplied speakers are exclusively for BD-MPC41U. Do not connect them to other
equipment, and do not connect other speakers to BD-MPC41U. It may cause malfunction.
Do not mistake the and , m and n right and left terminals of the speaker leads. (The right speaker is
placed on the right when you face the unit.)
Do not let the bare speaker wires touch each other.
Do not stand or sit on the speakers. You may be injured.
Insert the speaker plug fully with the rising side facing up.
Hold the speaker plug when removing it from the main unit. Pulling the lead may cause malfunction to
the unit.
•
•
•
•
•
•
About the wire arrangement of Sound Bar speaker
After connecting the speaker wires to the Sound Bar speaker, arrange the wires as shown in the following
illustration.
Rib Rib
Refer to ”Speaker Settings”. (Pages 39-40) •
After connecting
Incorrect Incorrect