Sharp Aquos TINS-E595WJQZ - Manual (Page 22)

20
To mount the Sound Bar Speaker on the wall
Positioning the Speaker System
ε Wall mount angle fixed on the wall
(Horizontal position)
Fix the pattern paper to the wall in horizontal
position as below.
29 mm
29 mm
44 mm
44 mm
509 mm
Pattern paper
Wall surface
Make a hole on the wall following the screw
point marks on the pattern paper by using a drill.
1-9/16" (40 mm)
3/8" (8-9 mm)
Wall surface
Fix a wall mount plug into the hole using a
hammer until it is flush with the wall surface.
1-9/16" (40 mm)
3/8" (8-9 mm)
Wall surface
Screw the wall mount angle to the wall as shown
in the illustration. (Total screw is 8 pieces)
Wall surface
Wall mount angle
Wall mount angle
(screws x 4)
(screws x 4)
Wall surface
Wall surface
Wall mount angle
NOTE
Make sure all screws are fully tighten. (screws are not
supplied) •
1
2
3
4
ε Installing the Sound Bar Speaker
Before installing the speaker, connect the speaker
connection cords to the speaker. (See pages 22-23.)
Align the wall mount slot at the speaker to the
wall mount angle.
Slot the speaker into the wall mount angle.
Fix them securely.
Wall surface
1
2
3