Stamina Products AVARI GX 8 - Manual (Page 12)

SET UP INSTRUCTIONS
LEVELING:
MOVING:
Equipment Mat
Place the Avari GX8 in the area where it will be used. It is recommended that the Avari GX8 be placed
on an equipment mat. The maximum usage dimensions of Avari GX8 are approximately 99 1/4" long x
25 5/8" wide x 64 7/8" tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 9 feet long is
required for safe operation of the Avari GX8. Make sure that adequate space is available for access to and
passage around the Avari GX8.
Adjust the STANDS(59) under the MAIN FRAME(1) so that the Avari GX8 sits on the floor
without rocking. Refer to the instructions below the illustration.
Move the Avari GX8 with the moving wheels on the REAR STABILIZER(2). Lift from the
Front Stabilizer of the MAIN FRAME(1). Two people are required to move the Avari GX8.
12
Lift up from the Front
Stabilizer for moving.
FUNCTION INSPECTION:
Visually inspect the Avari GX8 to verify that assembly is as shown in the above illustration. Check the
function of the Avari GX8. Stand on the foot pedals and place your hands at a comfortable position on the
handlebars. Slowly move your highest foot forward and follow the natural path of the machine. Turn the
crank slowly through one complete revolution to verify that the drive train functions properly. Use the "
Quick
Start " and " +/- " buttons on the COMPUTER(20) to select a program and verify that the Generator System
provides different tensions. Refer to the COMPUTER INSTRUCTIONS on pages 17 to 22.
Locate and read the WARNING LABEL(95) on the Avari GX8. Make sure that all users read
the WARNING LABEL(95). CAUTION:
To level the Avari GX8, first screw the STAND(59) located in
the middle of the MAIN FRAME(1) all the way up into the
MAIN FRAME(1) so that it is not touching the floor.
Adjust the four STANDS(59) on each of the four
corners, two under REAR STABILIZER(2) and
two under the front of the MAIN FRAME(1).
When all four are adjusted and the Avari GX8
is stable, tighten the
NUTS(3/8"-16) (79) against
the MAIN FRAME(1) and REAR STABILIZER(2)
to lock the STANDS(59) into position.
While you are adjusting these four STANDS(59),
the one STAND(59) located in the middle of the
MAIN FRAME(1) must not be in contact with the floor.
Only after the Avari GX8 has been stabilized with
the four STANDS(59) on the corners will you
position the middle STAND(59) so it is in
contact with the floor to provide extra
stability for the MAIN FRAME(1).