Woodstock SHOP FOX W1667 - Manual (Page 5)

- 3 -
Woodstock International, Inc. warrants all
SHOP FOX ®
machinery to be free of defects from work-
manship and materials for a period of 2 years from the date of original purchase by the original owner.
This warranty does not apply to defects due directly or indirectly to misuse, abuse, negligence or acci-
dents, lack of maintenance, or to repair or alterations made or specifically authorized by anyone
other than Woodstock International, Inc.
Woodstock International, Inc. will repair or replace, at its expense and at its option, the
SHOP FOX ®
machine or machine part which in normal use has proven to be defective, provided that the original
owner returns the product prepaid to the
SHOP FOX ®
factory service center or authorized repair
facility designated by our Bellingham, WA office, with proof of their purchase of the product within 2
years, and provides Woodstock International, Inc. reasonable opportunity to verify the alleged defect
through inspection. If it is determined there is no defect, or that the defect resulted from causes not
within the scope of Woodstock International Inc.'s warranty, then the original owner must bear the
cost of storing and returning the product.
This is Woodstock International, Inc.'s sole written warranty and any and all warranties that may be
implied by law, including any merchantability or fitness, for any particular purpose, are hereby limit-
ed to the duration of this written warranty. We do not warrant that
SHOP FOX ®
machinery complies
with the provisions of any law or acts. In no event shall Woodstock International, Inc.'s liability under
this warranty exceed the purchase price paid for the product, and any legal actions brought against
Woodstock International, Inc. shall be tried in the State of Washington, County of Whatcom. We shall
in no event be liable for death, injuries to persons or property or for incidental, contingent, special or
consequential damages arising from the use of our products.
Every effort has been made to ensure that all
SHOP FOX ®
machinery meets high quality and durabili-
ty standards. We reserve the right to change specifications at any time because of our commitment to
continuously improve the quality of our products.
INTRODUCTION
Specifications
Motor Type: ......................................................TEFC Capacitor Start Induction
Motor: ..............................................
1 ⁄
2
HP, 110V, 5 Amp., Single Phase ⁄ 60 Hz
RPM: ..............................................................................................1725
Power Transfer: ........................................................................ V-Belt Drive
Bearings: ....................................................Shielded & Lubricated Ball Bearings
Switch: ............................................Toggle ON/OFF Switch, W/ Safety Lock Tab
Oscillating Stoke Length: ........................................................................
1 ⁄
2
"
Spindle Travel: ..................................................................................1 5 ⁄
8
''
Maximum Distance, Spindle to Base: ..........................................................11''
Maximum Distance, Spindle to Table: ..........................................................8''
Overall Height: ....................................................................................23''
Dust Port Size: ..................................................................................2
1 ⁄
4
''
Spindle Taper: ..................................................................................JT-33
Table Swing: ....................................................................................8
1 ⁄
2
''
Table Tilt: ..........................................................................................90°
Chuck Size: ..........................................................
1 ⁄
2
'' (1-13mm JT-33), Keyed
Speeds:............................................................................5, Belt Controlled
Range of Speeds: ..................................................620, 1100, 1720, 2340, 3100 RPM
Drilling Capacity:............................................................
1 ⁄
2
'' Diameter in Steel
Approximate Shipping Weight: ..............................................................54 lbs.
Warranty and Returns