Woodstock SHOP FOX W1667 - Manual (Page 13)

-11-
Figure 10. Aligning the pocket in the headstock
with the column.
Figure 11. Securing the headstock to the
column.
Set screws
Headstock
To install the headstock, do these steps:
1. With an assistant, position the pocket over
the column and allow the headstock to
slide down until the column fully seats up
and into the headstock (approximately 2").
See
Figure 10.
2. Align the headstock directly over the foot
of the base as viewed from the front of the
drill press.
3. Tighten the two setscrews to secure the
headstock to the column. See
Figure 11.
GET assistance before
beginning the next step.
The headstock is a heavy
load.
The headstock must be tightened in position
with the setscrew so the headstock is aligned
with the drill press base for balance and
weight distribution. DO NOT over tighten the
set screw and strip the threads or bend the
column.
ASSEMBLY