Woodstock SHOP FOX W1667 - Manual (Page 25)

-23-
One of the great features of the Model W1667
8
1 ⁄
2
'' Oscillating Drill Press is its sanding capa-
bility. The drill press can be converted from
drilling operations to sanding operations in just
a few steps.
To use the oscillating feature, do these
steps:
1. UNPLUG THE DRILL PRESS!
2. Remove the spindle handles.
3. Lift the belt cover and remove the round
belt located on the storage bracket under
the speed chart. See
Figure 36.
4. Stretch the belt onto the top groove in the
spindle and oscillating pulley. See
Figure
37.
5. Close the cover. The motor will not start
until the cover is closed.
6. Loosen the jam nut for the depth stop and
adjust both nuts until they are positioned
at the top of the depth stop rod. Tighten
the jam nut. See
Figure 38.
Figure 36. Oscillator belt on storage bracket.
Figure 37. Stretch the belt to fit on pulleys.
Figure 38. Back-off the depth stop nuts.
UNPLUG the machine and
remove all handles before
using the oscillating fea-
ture. The handles swing
during operation.
Belt and
storage
bracket
ALWAYS back-off the depth stop complete-
ly and secure the depth stop nuts before
using the oscillating feature. If the depth
stop is left adjusted for a shallow hole, or
the nuts rattle down to the stop while in
operation, the depth stop will bottom out
and break the oscillator.
Using the Oscillator
NOTICE
OPERATIONS