Woodstock SHOP FOX W1667 - Manual (Page 26)

7. Choose the insert that has an opening
which is slightly bigger than the sanding
drum chosen. See
Figure 39.
8. Insert the sanding drum mandrel into the
chuck and set the chosen table insert into
the pocket in the top of the table. See
Figure 40.
• For general drill bits, small reamers, and
miscellaneous small cutting and sanding
bits, use the
5 ⁄
8
'' and the 1'' table inserts.
• For the 1'' sanding drum, use the 1 3 ⁄
8
''
table insert.
• For the 1 1 ⁄
2
'' sanding drum, use the 1 7 ⁄
8
''
table insert.
• For the 2'' sanding drum, use no table
insert.
9. Loosen and pivot the table so the opening
in the installed table insert is centered to
the drill bit or sanding drum.
10. Adjust the table height to use all of the
grit on the paper as the paper wears.
• If the thickness of the workpiece does not
allow much table movement and the
sanding drum paper is partially worn on
one end, remove the drum from the sand-
ing spindle, turn it end for end and
replace it on the sanding spindle to use
the newer part of the sandpaper.
11. Turn the drill press
ON, and begin sanding.
NEVER sand or drill
without the table in
position and the work-
piece secured. Serious
personal injury may
occur.
Figure 39. Sanding drum table insert.
Figure 40. Sanding drum installed.
-24-
OPERATIONS