Savin 7800W - Manual (Page 42)

Copy Settings
32
3
Setting a Leading/Trailing Edge Margin
You can set a margin on the leading or trailing edge of the copy when you use
Roll Feeder in the Synchro Cut mode. When using the bypass table, and Preset/
Variable Cut mode you can only set the trailing edge margin.
Note
❒ You can set up to a ±
99mm,
±
4.0" margin in 1mm, 0.1" steps on either the lead-
ing or trailing edge.
❒ When you set a leading margin, the copy image is shifted to the trailing edge.
The copy image is shifted to the trailing edge, when you make a copy using
the bypass table, or in the Preset Cut mode, Variable Cut mode.
A
Press the
{{{{Function Select}}}} key until the Leading Edge or Trailing Edge indi-
cator is lit.
B
Press the
{{{{+}}}} key and {{{{ −−−− }}}} key to specify an edge margin.
Note
❒ To clear the value, press the {Clear/Stop} key.
C
If you want to set both margins, press the Function select key and specify
the other margin.