Sun Microsystems THE SUN 805-7945-10 - Manual (Page 19)

Installing and Configuring the ge Device Driver 15
Note – The “name” property in the ge.conf file should be the same value as the
“compatible” property. In this case, the value is SUNW,sbus-gem . See page 7 for
more information about the .properties file.
For Sun GigabitEthernet/P:
To identify a PCI device unambiguously in the ge.conf file, use the name, parent
name, and the unit-address for the device. Refer to the pci (4) man page for more
information about the PCI device specification.
In the first line of the previous example:
■ Name = pci108e,2bad
■ Parent = /pci@4,4000
■ Unit-address = 4
In the second line in the previous example:
■ Name = pci108e,2bad
■ Parent = /pci@6,2000
■ Unit-address = 1
In the third line in the previous example:
■ Name = pci108e,2bad
■ Parent = /pci@4,2000
■ Unit-address = 1
▼ To Set Parameters Using the ge.conf File on an SBus
adapter
1. Set the ipg1 and ipg2 parameters for the above devices in the
kernel/drv/ge.conf file.
2. Save the ge.conf file.
3. Save and close all files and programs, and exit the windowing system.
4. If your system doesn’t support DR, reboot by typing the init 6 command at the
superuser prompt.
name = “SUNW,sbus-gem” class = “sbus”
reg=0x2,0x100000,0x14,0x2,0x200000,0x9060 ipg1=20 ipg2=10 ;